Zero latency mode on fabfilter Q3

Videos Jaycen Joshua - Mixing Workshop
1

Is there a reason to use only zero latency mode when using fabfilter Q-3?

2

Because it has practically no CPU usage. You can have a hundred of them going without it bogging down your system.

3 Likes
3

Thanks your reply. But my intention of the question is about phase, not cpu resources.

4

Feel like most engineers I’ve seen on here that use the Q3 (like Teezio) will only put it in natural/linear phase mode if they hear a reason to. If there’s no phase issues in ZL, then they just keep it there.

5

So, I wonder why Jaycen Joshua always uses Zero Latency

6

@Ross_Robinette Is correct. Its set by default that way so unless I hear a need to I wont change it

1 Like
7

Thanks your reply!!!

1 Like